Greetings,
I am always hesitant to post, because I don't want to get flamed for asking a question that has already been address. With that said, I did look around first. I'm curious about the Quick Cue Points [QCP] and how they are shared between channels 1 & 2.
Frequently I will attempt to manipulate the same track on both channels. I'll set a QCP on track 1 [or 2] and the QCP will not always auto populate on the other channel. One would do this to set up an on-the-fly beat juggling feat...but again I can't seem to get any consistency with the QCP setting. There are times when it has worked...other times when it'll work for QCP#1 and then again not at all.
I appreciate any [positive] input that someone could provide to address this issue I'm almost certain I'm doing something wrong, but I'm clueless

Still don't have an answer...over 500 views and no one seems to know. I thought I had it though....a couple of minutes ago I was screwing with the LOCK KEY AND SPEED virtual knob. I turned them off in fact and then MAGICALLY it the cues started to save on the fly for both tracks. THEN it stopped working...again

I believe in Torq 1.x that the quick cue's are not written to the TQD file until the song is unloaded from the deck. Have you tried doubling the song to the other deck after adding a quick cue to see if it doubles with the new quickcues?

Hey Jared! Thanks for stopping by my post

Dude [hope you don't mind] I've tried to figure this out and there really is no rhyme or reason to it

I just did it. Fired up Torq, loaded a track, played it, saved a cue point on side 1 and [POOF] it automatically shows up on side 2

You method worked too, loading side 2 after the fact...but again, it does work on the fly randomly

Do you have the latest update? Torq 1.5.2?

I'll ask around and see if anyone knows more about this.